Operating Instructions Installation InstructionsTroubleshooting Tips
Consumer Support
Safety Instructions
24
About the dryer features
Cycle Signal Option (on some models)
This signal will sound just before the end
of the cycle to remind you to remove the
clothes. On some models, the signal sound
level cannot be adjusted.
If you selected the WRINKLE CARE option,
the signal will sound at the end of the drying
time and will sound several times during the
WRINKLE CARE cycle. This will remind you
that it is time to remove the clothes.
NOTE:
Remove garments promptly at the sound
of the signal. Place clothes on hangers so
wrinkles won’t set in.
Use the Cycle Signal especially when
drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles won’t set in.
Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect
the dryer at the household distribution panel by removing the fuse or switching off the
circuit breaker. Reach above dryer opening from inside the drum. Remove the bulb and
replace with the same size bulb.
The stainless steel used to make the dryer drum provides the highest reliability
available in a GE dryer. If the dryer drum should be scratched or dented during normal
use, the drum will not rust or corrode. These surface blemishes will not affect the
function or durability of the drum.
At the end of each cycle, there is
approximately 15 minutes of no-heat
tumbling after the laundry is dry.
A reminder signal will sound periodically
during this time to remind you to
remove the laundry.
Drum Lamp
Stainless Steel Drum
(on some models)
Automatic Cycle Signal (on some models)
Wrinkle Care (on some models)
Use this option to minimize the wrinkles
in clothes. It provides approximately
15 minutes of no-heat tumbling after
the clothes are dry.
This option can only be used with the
COTTONS and
EASY CARE cycles.
If you are using the CYCLE SIGNAL knob
and you select the WRINKLE CARE option,
a signal will sound at the end of the drying time
and several times during the WRINKLE CARE
cycle. This will remind you that it is time to
remove the clothes.
If WRINKLE CARE is not on, the dryer
will stop once the timer reaches the
WRINKLE CARE mark on the cycle dial.
To Next Page
Loading...
