Installation Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
Safety Instructions
www.GEAppliances.ca
3
PROPER INSTALLATION
This dryer must be properly installed and located in accordance with the Installation Instructions before
it is used, present in this manual.
Properly ground dryer to conform to all governing
codes and ordinances. Follow details in
Installation Instructions section.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the
weather.
Connect to a properly rated, protected and sized
power supply circuit to avoid electrical overload.
Remove the protective lm from both the control
panel and the door.
Remove all sharp packing items and dispose of all
shipping materials properly.
Do not remove the vent protector from the back
of the dryer. Pull the protector out and down to its
lowest position and connect the exhaust duct to
the dryer. The lowered protector will prevent the
duct from getting crushed.
Dryers MUST be exhausted to the outside to
prevent large amounts of moisture and lint from
being blown into the room.
Use only rigid metal or exible metal 10 cm (4”)
diameter ductwork inside for exhausting to the
outside.
USE OF PLASTIC OR OTHER COMBUSTIBLE
DUCTWORK CAN CAUSE A FIRE. PUNCTURED
DUCTWORK CAN CAUSE A FIRE IF IT COLLAPSES
OR BECOMES OTHERWISE RESTRICTED IN USE
OR DURING INSTALLATION.
1
2
For complete details, follow the Installation
Instructions.
Exhaust/Ducting:
To Next Page
Loading...
Need help?
General