EasyManuals Logo

GE Dryers Use And Care

GE Dryers
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Installation Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
Safety Instructions
www.GEAppliances.ca
25
The Exterior: Wipe or dust any spills or washing
compounds with a damp cloth. Dryer control
panel and nishes may be damaged by some
laundry pretreatment soil and stain remover
products. Apply these products away from the
dryer. The fabric may then be washed and dried
normally. Damage to your dryer caused by
these products is not covered by your warranty.
The Lint Filter: Clean the
lint lter before each use.
Pull out the lint lter.
Moisten your ngers and
remove the captured lint.
Once clean, slide the lter
back into position. Have a
qualied technician vacuum
the lint from the dryer once a year.
Loading and using the dryer
Always follow the fabric manufacturer’s care label when laundering.
Sorting and Loading Hints
Care and Cleaning of the Dryer
As a general rule, if clothes are sorted properly for
the washer, they are sorted properly for the dryer.
Try also to sort items according to size. For example,
do not dry a sheet with socks or other
small items.
Do not add fabric softener sheets once the load
has become warm. They may cause fabric softener
stains. Bounce
®
Fabric Conditioner Dryer Sheets have
been approved for use in all GE Dryers when used
in accordance with the manufacturer’s instructions.
Do not overload. This wastes energy and causes
wrinkling.
Do not dry the following items: berglass items,
woolens, rubber-coated items, plastics, items with
plastic trim and foam-lled items.
The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a year to prevent clogging.
A partially clogged exhaust can lengthen the
drying time.
Follow these steps:
Stainless Steel: To clean stainless steel surfaces,
use a damp cloth with a mild, non-abrasive cleaner
suitable for stainless steel surfaces. Remove the
cleaner residue, and then dry with a clean cloth.
The Exhaust Hood: Check with a mirror that
the inside aps of the hood move freely when
operating. Make sure that there is no wildlife
(birds, insects, etc.) nesting inside the duct or hood.
Turn off electrical supply by disconnecting
the plug from the wall socket.
Disconnect the duct from the dryer.
Vacuum the duct with the hose attachment
and reconnect the duct.
1
2
3

Other manuals for GE Dryers

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Dryers and is the answer not in the manual?

GE Dryers Specifications

General IconGeneral
BrandGE
ModelDryers
CategoryDryer
LanguageEnglish

Related product manuals