47
ge.com
Problem Possible Causes What To Do
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
(on some models) blown or the circuit
breaker tripped.
The clock is turned off so that it • See the Using the clock and timer section.
does not show in the display.
Display flashes Power failure. • Reset the clock.
(on some models)
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be touched at
display to show “SF” not touched properly. the same time and held for 3 seconds.
(on some models)
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock and
(on some models) resetting any cooking function.
“Burning” or “oily” odor This is normal in a new oven • To speed the process, set a self-clean cycle for a
emitting from the vent and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise A cooling fan may automatically • This is normal. The cooling fan will turn off and on.
turn on and off to cool
internal parts.
Drawer does not slide The drawer is out of alignment. • Fully extend the drawer and push it all the way in.
smoothly or drags See the Care and cleaning of the range section.
Drawer is over-loaded or load • Reduce weight. Redistribute drawer contents.
is unbalanced.
Consumer SupportOperating InstructionsSafety Instructions Installation Instructions Troubleshooting Tips
To Next Page
Loading...
Need help?
General
