GEAppliances.com
Top-of-Range Cookware
Aluminum: Medium-weight cookware
isrecommended because it heQtsquickly
and evenly.Most foods brown evenly in
an aluminum skillet. UsesQucepQnswith
tight-fitting lids when cooking with minimum
amounts of water.
Cast-Iron: If heQted slowly, most skillets
will givesQtisfactory results.
Enamelware: Undersome conditions,
the enQmelof some cookware may melt.
Follow cookwQremanufacturer's
recommendQtionsfor cooking methods.
Glass: Thereore two types of gloss
cookware-those for oven use only Qndthose
for top-of-range cooking (sQucepQns,coffee
and teQpots).Glossconducts heQtvery
slowly.
HeutproofGluss-Cerumic: Conbe usedfor
either surface or ovencooking. It conducts
heQtvery slowly Qndcoolsvery slowly. Check
cookware manufacturer's directions to be
sure it can be usedon gQsranges.
Stainless Steel: This metal (]lonehQspoor
heQtingproperties and isusuQIlycombined
with copper,aluminum or other metalsfor
improved heat distribution. CombinQtion
metal skilletsusuQIlywork sQtisfactorily
if they are usedwith medium heQt
asthe manufacturer recommends.
Stove Top Grills (on models with sealed burners)
Do not usestove top grills on your seQledgas
burners. If you usethe stove top grill on the
sealedgas burner,it will cause incomplete
combustion and can result in exposure to
carbon monoxide levelsabove allowable
current standards.
Thiscan be hazardous to gout health.
Usea flat-bottomed wok.
Wok This Wag (on models with sealed burners)
Werecommend that you usea ! 4" or smaller
flat-bottomed wok. Hake sure the wok bottom
sitsflat on the grate. Theyare available at
your loca!retai!store.
Only a flat-bottomed wok should be used.
Do not usea flat-bottomed wok on a support
ring. Placingthe ring over the burner or grate
may cause the burner to work improperly,
resulting in carbon monoxide levelsabove
allowable standards. Thiscould be dangerous
to your health.
In Case of Power Failure
In caseof a power failure, you can light
the gas surface burners on your range with
a match. Holda lit match to the burner,
then pushin and turn the control knob
to the Life position. Useextreme caution
when lighting burners this way.
Surface burners in usewhen an electrical
power failure occurs will continue to operate
normally.
O_
Q
e_e
¢n
Cb
Q
Q
Q
ro
3"
w
¢}-
o
db
0
o_
"0
"0
0
To Next Page
Loading...
Need help?
General
