GEAppliances.com
Top-of-Range Cookware
Aluminum: Medium-weight cookware is
recommended because it heats quickly
and evenly.Mostfoods brown evenly in an
aluminum skillet.Usesaucepans with tight-
fitting lids when cooking with minimum
amounts of water.
Cast-Iron: Ifheated slowly, most skillets will
give satisfactory results.
Enamelware: Undersome conditions, the
enamel of some cookware may melt. Follow
cookware manufacturer's recommendations
for cooking methods.
Glass: There are two types of glass
cookware-those for oven use only and those
for top-of-range cooking (saucepans, coffee
and teapots). Glass conducts heat very slowly.
HeatproofGlass-Ceramic: Canbe usedfor
either surface or oven cooking. It conducts
heat very slowly and cools very slowly.Check
cookware manufacturer's directions to be
sure it can be usedon gas ranges.
Stainless Steel: This metal alone has poor
heating properties and is usually combined
with copper, aluminum or other metals for
improved heat distribution. Combination
metal skillets usuallywork satisfactorily if
they are used with medium heat as the
manufacturer recommends.
Stove Top Grills (onmodels with sealedburners)
Do not use stovetop grills on your sealed gas
burners. If you usethe stove top grill on the
sealedgas burner, it will cause incomplete
combustion and can result in exposureto
carbon monoxide levelsabove allowable
current standards.
Thiscan be hazardous to your health.
Use a flat-bottomed wok.
Wok This Way (on models with sealed burners)
We recommend that you use a 14" or smaller
flat-bottomed wok. Make sure the wok bottom
sits flat on the grate. They are available at your
local retail store.
Onlya flat-bottomed wok should be used.
Do not use a flat-bottomed wok on a support
ring. Placingthe ring over the burner or grate
may cause the burner to work improperly,
resulting in carbon monoxide levelsabove
allowable standards. Thiscould be dangerous
to your health.
i .......................... i
ii_ _i _i_i!!iiiiiiii_ "_iiiii_
In Case of Power Failure
In case of a power failure,you can light the gas
surface burners on your range with a match.
Hold a litmatch to the burner, then push in and
turn the control knob to the LITEposition. Use
extreme caution when lighting burners this way.
Surface burners in usewhen an electrical
power failure occurs will continue to operate
normally.
To Next Page
Loading...
Need help?
General
