Problem Possible Causes What To Do
“F –” and a number You have a function • Disconnect all power to the range for at least
or letter flash error code. 30 seconds and then reconnect power. If the function
in the display .ecivres rof llac ,staeper edoc rorre
gnirud sraeppa edoc rorre noitcnuf a fi ,sledom gninaelc-fles nO •
hctal ehT .hctal rood nevo eht kcehc ,elcyc gninaelc-fles eht
.noitisop dekcol eht morf ,ylthgils ylno fi ,devom neeb evah yam
.og lliw ti sa raf sa thgir eht ot devom si hctal eht erus ekaM
eht hcuoT Clear/Off pad. Allow the oven to cool for one hour.
.noitarepo otni kcab nevo eht tuP
Display flashes “bAd” The installed connection • Contact installer or electrician to correct miswire.
then “linE” with a from the house to the unit
loud tone is miswired.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown, or the circuit breaker
.deppirt
The clock is turned off from • See the Using the clock and timer and/or the Energy
showing in the display. Saver Mode section.
Unable to get the Oven control pads were • The Bake and Broil Hi/Lo pads must be touched
display to show “SF” not pressed properly. at the same time and held for 3 seconds.
Clock flashes, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
power outage eht gnihcuot yb ti Clear/Off pad, setting the clock
.noitcnuf gnikooc yna gnitteser dna
“Burning” or “oily” This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the
tsrif eht rof lamron si nevo
.desu si nevo eht semit wef
Drawer does not slide The drawer is out of • Fully extend the drawer and push it all the way in smoothly or
drags alignment. See the Care and cleaning of the range section.
Drawer is overloaded or load • Reduce weight. Redistribute drawer contents.
is unbalanced.
31
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Before you call for service…
To Next Page
Loading...
