-８-
5. CONNECTION AND OPERATION – EP700/1000/2000/3000
5.1 Inspection: Inspect the packaging carton and its contents for damage. Please inform
the transport agency immediately should you find signs of damage.
Please keep the packaging in a safe place for future use.
Note: Please ensure that the incoming feeder is isolated and secured to prevent it from
being switched back on again.
5.2 Connection:
1) UPS Input Connection
If the UPS is connected via the power cord, please use a proper socket with
protection against electric current, and pay attention to the capacity of the socket:
over 7A for EP 700/1000, over 12A for EP 2000 and over 16A for EP 3000.
2) UPS Output Connection
The output of EP 700/1000/2000/3000 are socket-types only. Simply plug the load
power cord to the output sockets to complete connection.
Model No. Output Socket (pcs)
EP 700 4
EP 1000 4
EP 2000 6 for Tower & 4 for Rack
EP 3000 6 for Tower & 2 for Rack
3) Computer Connection:
Connect your load to the outlet sockets of the UPS system directly.
5.3 Battery Charge: Fully charge the batteries of the UPS system by leaving the UPS
system connected to the mains for 1-2 hours. You may use the UPS system directly
The system may be installed and wired only by qualified electricians in
accordance with applicable safety regulations!
When installing the electrical wiring, please note the rated current
To Next Page
Loading...
Need help?
General