General Information
-
AF-300 MICRO-$AVERTM Drive Instructions
These instructions do not purport to cover all details or variations
In
equipment, nor to provide for
every possible contingency to be met during installation, operation, and maintenance. Should
further information be desired or should particular problems arise that are not covered sufficiently for
the purchaser’s purpose, the matter should be referred to GE Motors
&
lndustnal Systems, Cus-
tomer Service.
This document contains proprietary information of General Electic Company, USA and is furnished
to
its
customers solely to assist that customer in the installation, testing, and/or maintenance of the
equipment described. This document shall not be reproduced in whole or
in
part nor shall its
contents be disclosed to any third party without the written approval of GE Motors & Industrial
Systems, Fort Wayne, IN.
NOTE: The terms “inverter”, “controller”, and “drive” are sometimes used interchangably throughout
the industry. We will use the term “Drive” in thrs document.
AF-300 MICRO-$AVEFITM and X$DTM are trademarks of General Electric Company
Energy
$aver@
IS a registered trademark of General Electric Company.
The terms “AF-300 MICRO-$AVEf?” and
“AF900M$”
will be used Interchangeably throughout
this document.
WARNING: Always read the complete instructions
priortoapplyingpowerortroubleshootingtheequipment
and follow all procedures step by step.
SHOCK
HAZ4RD
labels may be located on or inside the Drive to alert people that dangerous
voltage may be present. (Refer to Section
1
Safety Precautions for Warnings and Cautions.)
Blank Space has been IntentIonally left at the bottom of each page for the convenience of the user
in documenting notes.
Copyright
Q
1995 by General Electric Company, USA.
i
To Next Page
Loading...
