41
37
Recalling Test Results and Average
4. Quick Searching: If you want to see all values automatically displayed in sequence, enter the memory mode. Press
and hold the Up or Down button for 2 seconds. (Down button is for searching the latest test value to the oldest one;
Up button scrolls from the oldest to the latest one). Anytime you want to stop, just release the pressed button. It will
stop and display the current value. Use this to check a particular reading.
5. Most Current Test Result: Press the Main button to enter the MEM (memory) screen and review the latest test result.
NOTE
- Control Solution Test results are not included in the Average calculations, but they can be recalled and
viewed.. The Control Solution Test results will show with “CS” symbol under memory screen.
CAUTION
- You have to set the time and date to activate the average function.
- The " " and " " results, the control solution results, and the test results measured when the meter was
outside of its operating temperature range will not be included in the average.
Caring for Your Meter
Maintenance
Keep your GE100 Blood Glucose Meter and Test Strip free of dust, water or any other liquid. Store the
meter in the carrying case when not in use. If meter is dropped or damaged, perform a quality control
test with the control solution before doing a blood glucose test.
Cleaning Meter
Clean the outside of the GE100 Blood Glucose Meter with a damp cloth and mild soap/detergent. Do
not get the test strip port wet.
Cleaning Test Strip Port
If your Test Strip Port is stained with blood, control solution or any liquid, please use a dry tissue or
alcohol swab to clean it immediately. Do not use anything wet to clean it. Perform a quality control test
to ensure that the GE100 Blood Glucose Meter is working properly.
40
To Next Page
Loading...
Need help?
General
