Navigating Service Mode Tests
69
• Rotating the knob counter clockwise shall decrement the
test number in the display.
• Rotating the knob clockwise shall increment the test
number in the display.
• Once the test number is selected, pressing Start/Pause
shall begin the selected test.
•
Individual Service Mode tests are exited by turning the selector knob
to a different test number.
NOTE: If there is no model information programmed, all segments of
the 7-Segment Display and LEDs shall blink and must be set as
described in the (t1) section Setting Model Codes on an Uninitialized UI
Card prior to entering Field Service Mode.
To Next Page
