Service Mode Tests
73
(t1) Setting and Viewing Model Codes:(2)
Setting Model Codes:
In the Dryer Model Codes (t1) test when Displaying Model Codes by
simultaneously pressing the two buttons Temp & Level the dryer Model
Codes can be set.
First the current User Interface Mode Type is first displayed and can be
adjusted as follows:
*** Pressing key Level will wrap though valid User Interface
Mode Type for the dryer and it increases until it wraps to the lowest
valid number.
*** Pressing key Temp will wrap thought valid User Interface
Mode Type and it decreases until it wraps to the highest valid
number.
To Next Page
Loading...
