GE GFWR4805 Service Manual (English)

Other manuals for GE GFWR4805

Technical Service Guide72 pages

Installation Instructions96 pages

Owner's Manual96 pages

Questions and Answers:

A
Alyssa MurphyAug 22, 2025
Why is my GE Washer not draining, spinning, or agitating?
- J
  jwoodsAug 22, 2025
  If your GE Washer isn't draining, spinning, or agitating, there are several possible causes: * The load might be unbalanced. Try redistributing the clothes and running a drain & spin or rinse & spin cycle. * The pump could be clogged. * The drain hose may be kinked or improperly connected. Ensure the drain hose is straight and the washer isn't sitting on it. * The household drain might be clogged. Check your household plumbing, and call a plumber if needed. * The drain hose might be siphoning because it's pushed too far down the drain. Make sure there's an air gap between the hose and the drain.
S
Susan McbrideAug 23, 2025
Why is my GE GFWR4805 Washer making loud noises and vibrating?
- E
  elijahwalshAug 25, 2025
  If your GE Washer is making loud or unusual noises, vibrating, or shaking, here's what to check: * The washer is designed to move slightly (about 1/4 inch), which is normal. * Ensure all rubber leveling legs are firmly touching the floor and locked in place. Adjust them if necessary. * The load might be unbalanced. Pause the unit, open the door, and manually redistribute the load.
G
Gabrielle KelleyAug 25, 2025
Why is water not entering my GE GFWR4805 Washer, or entering slowly?
- N
  natalie22Aug 26, 2025
  If water isn't entering your GE Washer or is entering slowly, consider the following: * The washer performs automatic self-system checks. Water will flow 60 seconds after you press Start. * Ensure both hot and cold water faucets are fully turned on. * The water valve screens might be clogged. Clean the screens in the machine using a brush or toothpick.
V
Victor PetersenAug 27, 2025
Why is my GE GFWR4805 Washer improperly dispensing softener or bleach?
- S
  shanepetersAug 27, 2025
  If your GE Washer is not dispensing softener or bleach properly: * Clean the dispenser drawer monthly to remove buildup of chemicals. * Make sure you are using the correct amount of softener or bleach and not filling above the max line.
L
Leslie BurnsAug 27, 2025
Why is the dispenser drawer in my GE GFWR4805 Washer not dispensing properly?
- N
  Nicholas MartinAug 27, 2025
  If the dispenser drawer in your GE Washer is not dispensing properly, it may be because a laundry detergent packet was placed in the dispenser drawer. Laundry detergent packets should not be used in the dispenser.
M
Michael PaceAug 29, 2025
How to troubleshoot a GE GFWR4805 that has no power?
- J
  Joshua FisherAug 29, 2025
  If your GE Washer has no power or isn't working, check these potential causes: * Ensure the washer is securely plugged into a working outlet. * Verify that both the hot and cold water faucets are fully turned on. * Check your house's circuit breakers or fuses. Replace any blown fuses or reset tripped breakers.
R
Ryan BeckAug 30, 2025
What to do if my GE GFWR4805 is leaking water?
- R
  Rhonda BurkeAug 30, 2025
  If your GE Washer is leaking water, consider these potential causes: * Check the door gasket for damage, ensuring it's correctly seated and not torn. Remember that objects left in pockets (like nails or pens) can cause damage. * The household drain may be clogged. Check your plumbing, and call a plumber if necessary. * The dispenser might be clogged, especially if you're using powder soap. Remove the drawer and clean both the drawer and the inside of the dispenser box. * You might be using too much detergent, leading to oversudsing. Try using less detergent.
K
karen01Aug 31, 2025
Why are my clothes too wet after washing in my GE Washer?
- D
  David LongAug 31, 2025
  If your clothes are too wet after a wash in your GE Washer, here are a few things to check: * The load might be unbalanced. Try redistributing the clothes and running a drain & spin or rinse & spin cycle. * The pump could be clogged. * You may be overloading the washer. The dry weight of the load should be less than 16 lbs.
E
edward31Sep 1, 2025
Why is there not enough water in my GE GFWR4805 Washer?
- T
  Teresa MannSep 1, 2025
  If it seems like your GE Washer isn't using enough water, note that horizontal washers don't require the basket to fill with water like top-load washers; this is normal.
K
Kelly PhamSep 3, 2025
How to get rid of a bad odor inside my GE Washer?
- C
  Claudia AyalaSep 3, 2025
  If there's a bad odor inside your GE Washer, it could be due to the washer being unused for a long time, not using the recommended quality of HE detergent, or using too much detergent. Try running a Tub Clean cycle.

GE GFWR4805 Specifications

General

Brand	GE
Model	GFWR4805
Type	Front Load Washer
Capacity	4.8 cu. ft.
Color	White
Energy Star Certified	Yes
Spin Speed	1300 RPM
Control Type	Electronic
Steam Function	Yes
Sanitize Cycle	Yes
Number of Wash Cycles	12
Width	27 inches
Height	39 inches