Separate for cleaning
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
6
About washer features.
Cleaning the Fabric Softener Dispenser (on some models)
1
Remove the dispenser from the top of the agitator.
2
Separate the dispenser cup from the cover by grasping the top and pushing down on the
inside of the cup with your fingers. Dispenser cup will pop free from the cover.
3
To clean the dispenser, soak both the dispenser cup and the dispenser cover in the
following solution:
1 US gallon (3.8 liters) warm water
1/4 cup (60 ml) heavy-duty liquid detergent
1 cup (240 ml) bleach
4
If necessary, loosen buildup with a clean, soft cloth after soaking. Do not use a stiff brush;
you may roughen the surface of the dispenser.
5
Rinse and reassemble dispenser. Place dispenser back on the agitator.
Fabric Softener Dispenser (on some models)
The fabric softener dispenser automatically
releases liquid fabric softener. Setting the
knob ensures that it dispenses at the proper
time.
Do not stop the washer or raise the lid
during the first spin. This will cause the
dispenser to empty too soon.
To use, follow these steps:
1
Make sure dispenser is securely attached
to agitator.
2
Use only diluted liquid fabric softener.
Pour into dispenser, using amount
recommended on package.
Never pour fabric softener directly on items.
It may stain them.
3
Add water to dispenser until it reaches
the maximum fill line.
Select FABRIC SOFTENER setting knob to
activate the cycle.
Note: Fabric softener will not dispense if the
knob is in the “OFF” position.
Do not pour anything into the
agitator if the agitator cap or
dispenser is removed.
4
The Agitator Cap (on some models)
The agitator cap fits into the top of the
agitator. If it accidentally comes off,
simply put it back on.
OPTIONS
OFF
FABRIC SOFTENER
and/or POWER RINSE
Set when adding
To Next Page
Loading...
Need help?
General
Weight and Dimensions
