72 7372 73
Connecting the camera and printer.
1. Make sure both the camera and printer are
turned on.
2. Connect one end of the supplied USB cable
to the USB port on your camera.
3. Connect the other end of the cable to the
USB port on the printer.
If the camera is not connected to a PictBridge
compatible printer, the following error
message appears on the LCD screen.
The above error message would
also appear if the USB mode were
set incorrectly, in which case you
should disconnect the USB cable,
check the USB mode settings,
ensure that the Printer is turned
on, and then try connecting the
USB cable again.
To Next Page
Loading...
Need help?
General
