GE IS200ADIIH A Series - Page 6

•
••
•
Auxiliary Drive to ISBus Interface Board IS200ADII GEI-100305
6
Table 4. Boolean Signals
Request Bits
Innovation Series
bit #
Innovation
Series
Mnemonic
AcDc2000 Feedback Bits
AcDc2000
bit #
Innovation
Series
Mnemonic
Innovation
Series
0
Heartbeat ref, lan LAN_HTBT_REF AUXCMD00
0
AUXFB00 LAN_HTBT_FBK Heartbeat fbk, lan
1
Fault reset req, lan LAN_FLT_RST SOFTRES
1
NOFAULT NO_FLT No faults active
2
Trip request, lan LAN_TRP_REQ CFGCMD32 (V.1422)
2
TRIPFLT TRIP_FLT Trip fault active
3
Alarm request, lan LAN_ALM_REQ CFGCMD33 (V.1423)
3
AUXFBW32.0 LOC_FLT Local Fault string
4
Undefined
 
4
AUXFBW32.1 SYS_FLT System fault string
5
Undefined
 
5
AUXFBW32.2 RUN_RDY Ready to Run
6
Undefined
 
6
MPWRENAB BRG_PWR_ENB Bridge is on
7
Undefined
 
7
RUNNING RUNNING Running
8
Run request, lan LAN_RUN_REQ RUNRQ (V.650)
8
RUNACT RUN_ACT Run Active
9
Jog request, lan LAN_JOG_REQ JOGRQ (V.651)
9
JOGACT JOG_ACT Jog Active
10
X stop request, lan LAN_XSTP_REQ CFGCMD34 (V.1424)
10
AUXFBW32.3 X_STP_CMD X stop active
11
Full flux req, lan LAN_FFLX_REQ CFGCMD35 (V.1425)
11
AUXFBW32.4 FLX_ENB_STAT Flux enable status
12
Rev mode req, lan LAN_REV_REQ REVCMD (V.675)
12
AUXFBW32.5 REVERSE Reverse mode
active
13
Torque mode req, lan LAN_TREF_ENB CURFOLRQ (V.684)
13
AUXFBW32.6 TRQ_MODE_ACT Torque mode
active
14
Droop disab req, lan LAN_DRP_INH BIASDINH (V.724)
14
AUXFBW32.7 SPD_MODE_ACT Speed mode active
15
Trq lim 2 sel, lan LAN_TLIM_SEL RCLILIM (V.695)
15
AUXFBW32.8 TRQ_LIM_ACT In cur or trq limit
16
Ramp rate 2 sel, lan LAN_RMP_SEL ALTRAJSU (V.643)
16
AUXFBW32.9 LOCAL_MODE Local mode active
17
Ramp hold req, lan LAN_RMP_HOLD HOLDSPD (V.699)
17
AUXFBW32.10 MA_ENB_STAT MA cont enable stat
18
Auto mode req, lan LAN_AUTO_REQ AUTOCMD (V.683)
18
Undefined
 
19
Undefined
 
19
ZEROSPD ZERO_SPD Zero speed active
20
Undefined
 
20
Undefined
 
21
Undefined
 
21
Undefined
 
22
Undefined
 
22
Undefined
 
23
Undefined
 
23
Undefined
 
24
GP lan req bit 1 LAN_B01_REQ AUXCMD01 (V.661)
24
(EE.781) AUXFB01 LAN_B01_ADR LAN_B01_ADR
25
GP lan req bit 2 LAN_B02_REQ AUXCMD02 (V.662)
25
(EE.782) AUXFB02 LAN_B02_ADR LAN_B02_ADR
26
GP lan req bit 3 LAN_B03_REQ AUXCMD03 (V.663)
26
(EE.783) AUXFB03 LAN_B03_ADR LAN_B03_ADR
27
GP lan req bit 4 LAN_B04_REQ AUXCMD04 (V.664)
27
(EE.784) AUXFB04 LAN_B04_ADR LAN_B04_ADR
28
GP lan req bit 5 LAN_B05_REQ AUXCMD05 (V.665)
28
(EE.785) AUXFB05 LAN_B05_ADR LAN_B05_ADR
29
GP lan req bit 6 LAN_B06_REQ AUXCMD06 (V.666)
29
(EE.786) AUXFB06 LAN_B06_ADR LAN_B06_ADR
30
GP lan req bit 7 LAN_B07_REQ AUXCMD07 (V.667)
30
(EE.787) AUXFB07 LAN_B07_ADR LAN_B07_ADR
31
GP lan req bit 8 LAN_B08_REQ AUXCMD08 (V.738)
31
(EE.788) AUXFB08 LAN_B08_ADR LAN_B08_ADR
Notes:
For CFGCMDx reference bits to be active, drive EE.762.8 (LDRVJP.8) must be set.
For AUXFBW32.x feedback bits to be active, drive EE.5626 (AUXFBJP) must be set to 3 (bits .1 & .0 must be set).