GE 90*-30 PLC Series User Manual

I/O
PEN*
Programmable Control Products
Series 90*-30 PLC
L
ON
W
ORKS*
Bus Interface Module
User's Manual
GFK-1322 January 2010

GE 90*-30 PLC Series Specifications

General

Type	PLC (Programmable Logic Controller)
Manufacturer	GE (General Electric)
Memory	Varies by model
Communication Ports	Ethernet
Power Supply	24V DC or 120/240V AC
Programming Languages	Ladder Logic, Function Block Diagram
Operating Temperature	0°C to 60°C (32°F to 140°F)
Weight	Varies by model

Summary

Chapter 1 Overview

LBIM Module Introduction

Introduces the Series 90 PLC LONWORKS Bus Interface Module (LBIM) and its function.

LBIM Configuration Overview

Outlines the process of defining network variables and mapping them into PLC memory.

Chapter 2 Operation

LBIM Operation Overview

Describes how the LBIM communicates with LONWORKS nodes and the PLC CPU.

LBIM Powerup Sequence

Details the self-test sequence performed by the LBIM during powerup.

Chapter 3 Hardware Installation

LBIM Module Installation and Removal

Details the physical steps for installing and removing the LBIM module from the PLC rack.

LBIM Network Connection

Covers the process of connecting the LBIM to the LONWORKS network infrastructure.

Connecting a Configuration Programmer

Explains how to connect a computer for configuring the LBIM.

Chapter 4 Configuring the LBIM

Using the LBIM Configuration Software

Guides the user through installing and running the LBIM configuration utility.

Binding Network Variables

Describes how to establish connections between network variables and the LBIM.

Editing LBIM Configurations

LBIM Module Configuration Parameters

Details setting general parameters like Program ID for the LBIM module.

Register Configuration Details

Covers configuring register parameters like start address, size, and length.

Configuration Editor Fields Overview

Defining LBIM Network Variables

Details the process of adding and defining new network variables for the LBIM.

Network Variable Editor Fields Explained

Details all fields within the Network Variable Editor for configuration.

Binding Network Variables to the Network

Describes the process of installing and binding variables within the LONWORKS network.

Chapter 5 Troubleshooting

Startup and Configuration Troubleshooting

Addresses common problems during LBIM powerup and configuration.

Appendix A Specifications

LBIM Module Specifications

LBIM Interface Specifications

Appendix B Standard Network Variable Types

SNVTs Supported by LBIM

Appendix C Configuration File Specifications

Appendix Q Quick Start Guide

LBIM Hardware Installation and Powerup

Covers the quick steps for installing and powering up the LBIM.

LBIM Configuration and Network Installation

Guides through the initial configuration and network setup for the LBIM.

LBIM PLC Configuration

Explains how to configure the Series 90 PLC to recognize the LBIM.