GE 90*-30 PLC Series User Manual

GFK-1322A Chapter 1 Overview 1-9
1
What You Need to Operate the Bus Interface Module
To configure and operate the LBIM, you need:
• A personal computer or laptop computer that runs Microsoft
®
Windows
®
software.
• Series 90-30 backplane with CPU module
See Table 1-7 for models that can be used with the LBIM.
• Logicmaster 90 software
Required to configure and program the Series 90-30 PLC. See Table 1-7 for versions that can
be used with the LBIM.
• L
ON
W
ORKS
network binding tool
Many third-party network management software packages that include network binding tools
are available. (See Table 1-8 for suggestions.)
• IOPEN network interface configuration software: (for Microsoft Windows) This software is
provided on the utility disk supplied with the LBIM.
• A L
ON
T
ALK
adapter and a device driver (See Table 1-9 for the adapter types that can be used
by each model of LBIM.)
This is required to run the network interface configuration software.
®
Windows is a registered trademark of Microsoft Corporation.

GE 90*-30 PLC Series Specifications

General

Brand	GE
Model	90*-30 PLC Series
Category	Computer Hardware
Language	English