Care and cleaning of the range. GEAppliances.com
Oven Light Replacement (on some models)
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect
the electrical power to the range at the main fuse or circuit breaker panel.
Failure to do so may result in electric shock or burn.
WARNING
BURN HAZARD: The glass cover and bulb should be removed when cool.
Touching hot glass with bare hands or a damp cloth can cause burns.
CAUTION
25
To remove the cover:
Hold a hand under the cover so it doesn’t
fall when released. With fingers of the
same hand, firmly push back the wire
cover holder. Lift off the cover.
Do not remove any screws to remove the
cover.
Replace bulb with a 40-watt household
appliance bulb.
To replace the cover:
Place it into groove of the light receptacle.
Pull wire forward to the center of the cover
until it snaps into place.
Connect electrical power to the range.
For models JBS27DI and JBS27RI: Replace
oven lamp with 240 volts lamp only.
Wire cover holder
The stainless steel handles (on some
models) can be cleaned with a commercially
available stainless steel cleaner. Cleaners
with oxalic acid such as Bar Keepers Friend
Soft Cleanser™ will remove rust, tarnish, and
small blemishes. Use only a liquid cleanser
free of grit and rub in the direction of the
brush lines with a damp soft sponge. Do not
use appliance wax or polish on the stainless
steel.
Do not wipe the handle with a soiled dish
cloth or wet towel. Do not use scouring
pads, powdered cleaners, bleach or cleaners
containing bleach because these products
can scratch and weaken the finish.
Stainless Steel Handles (on some models)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
