EasyManuals Logo

GE JCBP24 User Manual

GE JCBP24
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Problem Possible Causes What To Do
Oven door will Oven too hot. Allow the oven to cool below locking temperature.
not unlock
Oven not clean after a Oven controls not properly set. See the Using the self-cleaning oven section.
clean cycle
Oven was heavily soiled. Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“F – and a number You have a function Press the OFF pad. Put the oven back into
or letter” flash error code. operation.
in the display
If the function code repeats. Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
If a function error code appears during the
self-cleaning cycle, check the oven door latch.
The latch may have been moved, if only slightly,
from the locked position. Make sure the latch is
moved to the right as far as it will go. Press the OFF
pad. Allow the oven to cool for one hour. Put the
oven back into operation.
Display flashes “bAd” The installed connection Contact installer or electrician to correct miswire.
then “linE” with a from the house to the unit
loud tone is miswired.
Display goes blank A fuse in your home may be Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off from See the Using the clock and timer section.
showing in the display.
Display flashes Power failure. Reset the clock.
Unable to get the Oven control pads were The BAKE and BROIL pads must be pressed
display to show “SF” not pressed properly. at the same time and held for 3 seconds.
Power outage, Power outage or surge. Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the OFF pad, setting the clock and
resetting any cooking function.
“Burning” or “oily” This is normal in a new To speed the process, set a self-clean cycle for a
odor emitting from oven and will disappear minimum of 3 hours. See the Using the self- cleaning
the vent in time. oven section.
Strong odor An odor from the insulation This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
No power supply from Small appliance plug is not Make sure the small appliance plug is properly
convenience outlet completely inserted in the inserted.
on top of backguard convenience outlet.
(on some models)
The backguard is too hot Allow the range to cool, then reset the circuit
and the convenience outlet breaker by pressing the switch located near the
breaker has tripped. convenience outlet.
www.GEAppliances.ca
31
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips
Consumer Support

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE JCBP24 and is the answer not in the manual?

GE JCBP24 Specifications

General IconGeneral
BrandGE
ModelJCBP24
CategoryRanges
LanguageEnglish

Related product manuals