GE JCBP24 User Manual

Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips
Consumer Support
9
www.GEAppliances.ca
Oven Control, Clock and Timer Features and Settings
AUTOMATIC OVEN Light (on some models)
This lights anytime the oven has been
programmed using the COOK TIME or
START TIME functions.
OVEN LIGHT or Pad
Touch this pad to turn the oven light on or
off.
– Pad
Short taps to this pad will decrease the time
or temperature by small amounts. Touch
and hold the pad to decrease the time or
temperature by larger amounts.
+ Pad
Short taps to this pad will increase the time
or temperature by small amounts. Touch
and hold the pad to increase the time or
temperature by larger amounts.
CLEAN Pad (on some models)
Touch this pad to select the self-cleaning
function. See the Using the self-cleaning oven
section.
CLEAN Light
Flashes while in edit mode—you can change
the length of time for the self-clean cycle at
this point. Glows when the oven is in the self-
clean cycle. After the self-clean cycle, the light
will turn off. Unlatch the door.
OFF Pad
Touch this pad to cancel ALL oven
operations except the clock and timer.
BROIL Pad
Touch this pad to select the broil function.
BROIL Light
Flashes while in edit mode—you can switch
from HI to LO BROIL at this point. Glows when
the oven is in broil mode.
Indicator Lights (on some pads)
EDIT mode lasts several seconds after the last
pad press. START TIME and COOK TIME will be
the only pads lit if either of these options is
selected. (Example: START TIME is selected
with BAKE—the START TIME pad will remain lit
until the clock reaches the programmed time,
at which point it will turn off and the BAKE
pad light will light up).
Fahrenheit° 140 150 170 200 250 275 300 325 350 375 400 425 450 475 500 525 550
Celsius° 60 65 75 95 120 135 150 160 175 190 205 220 230 245 260 275 290
Temperature Conversions
Convenience Outlet
(on some models)
The 120V convenience outlet located on the top
of the backguard may be used to plug in small
electrical appliances.
When using the outlet, be sure that the electrical
cord does not rest on or near a surface unit.
If the surface unit is turned on, the cord will
be damaged.
To reset the circuit breaker, press the switch
located near the outlet on top of the backguard.
Power Outage
If a flashing time is in the display, you have experienced a
power failure. Reset the clock.
To reset the clock, touch the CLOCK pad. Enter the
correct time of day by touching the + or – pads.
Touch the START/ON pad.

GE JCBP24 Specifications

General

Brand	GE
Model	JCBP24
Category	Ranges
Language	English