GE JGP328 Installation Instructions

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
CHANGE COOKTOP BURNER
ORIFICES
Remove the top
grates, burner caps,
and burner heads.
[] Remove the spark
igniters from the
burner base (if
required to access
the orifices). Using a
No. 15 "Torx" head
driver bit, remove the
screws holding the
burner base in
position.
[] Using a 7mm nut
driver, remove the
top burner orifices.
These may be
accessed through the
hole in the cooktop.
Remove
This
Orifice Spud Located
Through This Opening
Burner cap
nor
Spark igniter base
18,000BTUBurner
(on somemodels)
Burner
cap
_Burner
_head
Burner_
base
Spark igniter
[] CHANGE COOKTOP BURNER
ORIFICES (CONT.)
NOTE: On most burners,
the orifices have a spring- Retainer
loaded retaining ring Ring
around the hex head to
hold the orifice in the nut
driver during installation
and removal. A slight amount of force is
required to push the nut driver down over
the ring.
14

GE JGP328 Specifications

General

Brand	GE
Model	JGP328
Category	Cooktop
Language	English