Usingtheoven.
Before you begin...
%
[]
%
[]
Look at the controls. Be sure you
unde,_mnd how to set them properly.
Check tile oven interior Look at
file shelves. _d<e a practice run at
removing and replacing them
properly to give sure, sturdy support.
Read over the infbrmafion and tips
that follow.
Keep this guide handy so you can
refer to it, especially during tile first
weeks of using your new oven.
NOTES:
Youmay notice a "burning" or "oily" smefl
the first few times you turn your oven on.
This is normal in a new oven and will
disappear in a short time. Tospeed the
process, set a Self-Clean cycle for 4 hours.
See the Using the Self-Cleaning Oven
section.
A cooling fan may automaticallytom on
andoff to cool internal parts. Thisis normal,
andthe fanmaycontinue to run evenafter
theovenisturnedoff.
Automatic Ignition
Theovenburner is lit byelectric ignition.
To light tile burne_; do tile fbllowing:
[_ Touch tile pad for the desired
flmction. Then touch tile ÷ or-
pad until the desired temperature is
displayed. Tile burner should ignim
within 60 seconds.
Aider the oven reaches file selected
temperature, file oven burner cycles off
completely; then on with a flfll flame to
keep tile (wen mmpemture controlled.
_ii ii i
Oven Vent
When tlle oven is on, heated air moves
through a vent behind the grille.
The vent area coukt get hot during
oven use.
Tile vent is needed for proper air flow in
the oven and good baking restflts. Do not
block this vent. Doing so may cause oven
failure or fire.
Power Outage
The oven burner will not light in the event
of an electrical power outage.
CAUTION:Do not attempt to light it manually
with a match.
Oven tight
Touch tile OVENUGHTpad to mrn the light
on or off.
14
To Next Page
Loading...
