Beforeyoucall for service...
Troubleshooting tips
Possible Causes What ToDo
"F-- and a number You have a function
orletter"flash error code.
in the display If the function * Disconnect all power to tile oxen for at least 30
code repeats, seconds and then reconnect power. If tile flmction
error code repeats, call fi_r serxice.
Displaygoesblank A fuse in your home may * Replace tile fllse or reset tile circuit breakei;
be blown or the circuit
breaker tripped.
The clock is in the * See tile Special features of your oven centre/section.
black-out mode.
Oisplayflashes Power failure. * Reset tile clock,
Unable to get the Oven control pads were * Tile Bake and Broil Hi/Lopads must be pressed
display to show ,SF! not pressed properly, at tile same dine and held for 3 seconds.
Power outage, Power outage or surge. * Reset tile clock. If the oven was in use, you must reset
clock flashes it 1)v,I)ressing, tile Clear/Off pad, settin,,_ tile ch)ck
and resetting an)cooking flmction.
"Burning," or ?oily '_ This is normal in a * To speed tile process, set a sel6clean cxcle for a
odoremitting from new oven mad will minimmn of 3 ho/lYS. See tile Using the self-cleaning
thevent disappear in time. oven section.
StrongOdor An odor from the insulation * This is temporar).
around the inside of the
oven is normal for the first
few times the oven is used.
• Press tile Clear/Off pad. _Mlow tile o_en to cool fin.
one ho/u; Put tile o'.en back into operation.
Fannoise
A cooling fm_ may
automatically turn on.
• This is normal. Tile cooling tim will turn on
to cool internal parts. It may itm tin" up to 1-I/2
hours in 30" models and up to 9 horn's in 27" models
after tile oven is tin'ned off.
28
To Next Page
Loading...
Need help?
General
