GE JP950 User Manual

7
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Customer Service
Bridge Burner
Make sure the pan rests flat on the glass
cooktop and it is not resting on the trim.
If you notice poor cooking performance,
move the pan to make sure it is flat on the
cooktop.
When the burner select knob points to
BRIDGE, the LEFT knob controls both the
left front surface unit and the bridge area.
Choose pans that match the circle/bridge
area as closely as possible.
When the burner select knob points to
FRONT, the LEFT knob controls the left
front surface unit only.
You can create an oblong heated area by using
the left rear unit in addition to the front unit
bridge combination.
Dual Surface Unit
The right front surface unit has 2 cooking sizes to
select from so you can match the size of the unit
to the size of the cookware you are using.
To use the large (9 inch) surface unit,
turn the COIL SIZE knob clockwise to .
Push in and turn the control knob to the
desired setting. The unit will heat the
entire area contained by the larger circle.
To use the small (6 inch) surface unit,
turn the COIL SIZE knob counterclockwise
to . Push in and turn the control knob
to the desired setting. The unit will only
heat the area inside the smaller circle.
Small 6 "
surface unit
setting
Large 9
"
surface unit
setting
Temperature Limiter
Every radiant surface unit has a
temperature limiter.
The temperature limiter protects the
glass cooktop from getting too hot.
The temperature limiter may cycle the
units off for a time if:
■ The pan boils dry.
■ The pan bottom is not flat.
■ The pan is off center.
■ There is no pan on the unit.

GE JP950 Specifications

General

Brand	GE
Model	JP950
Category	Cooktop
Language	English