Beforeyoucall forservice...
Troubleshooting -tips
Possible Causes What ToDo
"F--andanumber You have a fm_ction
orletter"flash error code.
in the display If the function * Disconnect all power to the oxen for at least 30
code repeats, seconds and then reconnect power. If the flmction
error code repeats, call tor serxice.
Oisplaygoesblank A fuse ha your home may * ]_eplace the fuse or reset the circuit breakei:
be blo_a or the circuit
breaker tripped.
The clock is in the * See the Special features of your oven control section.
black-out mode.
Displayflashes Power failure. * Reset the clock.
Unable to getthe Oven control pads were * The BAKE and BROIL HI/LO pads must be touched
display to show "SF" not pressed properly, at the same time and held for 3 seconds.
Power outage, Power outage or surge. * Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFFpad, ,settim,_the clock
and resetting an} cooking flmction.
"Burning" or "oily" This is normal in a * To speed the process, set a self-clean cxcle fi)r a
odor emitting from new oven mad will minimum of 5 hours. See the Using the self-cleaning
the vent disappear in time. oven section.
Strongodor An odor from the insulation * This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
• Touch the CLEAR/OFFpad. _Mlow the oven to cool for
one horn: Put the oxen back into operation.
Fannoise
A cooling fm_ may
automatically turn on.
• This is normal. The cooling tim will mrn on to cool
internal parts. It max run for up to 2 hours after the
oxen is turned off.
24
To Next Page
