41
Problem Solver
PROBLEM POSSIBLE CAUSE
“F–AND A NUMBER • This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
OR LETTER” FLASH hour. Place the oven back into operation.
IN THE DISPLAY
• Disconnect all power to the oven for 5 minutes and then reconnect power. If the
failure code repeats, call for service.
DISPLAY GOES BLANK • The circuit breaker in your house has been tripped, or a fuse has been blown.
DISPLAY FLASHES • Power failure. Reset the clock.
UNABLE TO GET THE • BAKE and BROIL HI/LO must be pressed at the same time and held for
DISPLAY TO SHOW “SF” 2 seconds.
“LOCK DOOR” FLASHES • Oven door not closed after self-clean cycle is selected.
“LOCKED DOOR” FLASHES • Door is still locked and you are trying to enter an oven cooking operation.
DOOR WILL NOT OPEN • When the temperature has fallen below the locking temperature, the door can
AFTER SELF-CLEAN CYCLE be opened.
CONTROL SIGNALS AFTER • This is reminding you to press BAKE and then enter a temperature.
ENTERING COOKING TIME
• This is reminding you to enter a bake temperature after having pressed BAKE.
OR DELAY START TIME
• This is reminding you to close the oven door so the self-clean cycle can start.
CLOCK AND TIMER • Make sure the electrical plug is plugged into a live, properly grounded
DO NOT WORK power outlet.
• Check for power outage.
• See the Oven Control, Clock and Timer section.
OVEN WILL NOT WORK • The plug on the range is not completely inserted in the electrical outlet.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• The oven controls are not properly set.
(continued next page)
To Next Page
Loading...
Need help?
General
