Why does my GE JT5500 Oven have a strong odor when it's new?
An odor from the insulation around the inside of the GE oven is normal for the first few times the oven is used. This is temporary and will go away after several uses or a self-clean cycle.
What to do if my GE Oven temperature is too hot or too cold?
If your GE oven temperature is too hot or too cold, the oven temperature may need adjustment. See the Special Features section for instructions.
Why is 'LOCK DOOR' flashing on my GE JT5500 display?
The 'LOCK DOOR' message flashes on the display because the self-clean cycle has been selected, but the oven door is not closed. Ensure the oven door is fully closed.
What to do if my GE JT5500 Oven door will not open after a clean cycle?
If your GE oven door won't open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool below the locking temperature.
What to do if my GE JT5500 will not self-clean?
If your GE oven will not self-clean, the temperature might be too high to set a self-clean operation. Allow the oven to cool and reset the controls. Also, make sure the oven controls are properly set (see the Cleaning the Oven section).
What does 'F— and a number or letter' mean on my GE JT5500 Oven display?
The 'F— and a number or letter' message on your GE oven display indicates a function error code. Press the Cancel/Off pad and allow the oven to cool for one hour. Then, put the oven back into operation. If the error repeats, disconnect all power to the oven for at least 16 seconds and then reconnect power. If the function error code repeats, call for service.
Why does my GE Oven sometimes take longer to preheat to the same temperature?
Several factors can affect preheating time: * Cookware or food in the oven will cause it to take longer to preheat. Remove items to reduce preheat time. * Adding more racks to the oven will increase preheat time. Remove some racks. * Different cooking modes use different preheat methods. Some modes will take longer than others (i.e., convection bake multi).
What to do if my GE JT5500 Oven display goes blank?
If your GE oven display goes blank, check if a fuse in your home may be blown or the circuit breaker tripped and replace the fuse or reset the circuit breaker. Also, the clock may be turned off (see the Special features section), or the oven may be in Sabbath Mode (verify, that the oven is not in Sabbath Mode in the Special Features section).
Why is the LOCKED light on when I want to cook in my GE JT5500 Oven?
The oven door is locked because the temperature inside the GE oven has not dropped below the locking temperature. Press the Cancel/Off pad and allow the oven to cool.
Why does "LOCK DOOR" flash on my GE JT5500 Oven display?
The "LOCK DOOR" message flashes when the self-clean cycle has been selected, but the door is not closed. Simply close the oven door.
General| Brand | GE |
|---|---|
| Model | JT5500 |
| Oven Type | Single |
| Fuel Type | Electric |
| Oven Capacity | 5.0 cu. ft. |
| Number of Ovens | 1 |
| Number of Oven Racks | 2 |
| Self-Cleaning | Yes |
| Convection Cooking | Yes |
| Broiler | Yes |
| Bake Element Wattage | 2500 W |
| Clock Type | Digital |
| Timer | Yes |
| Control Lock | Yes |
| Control Type | Touch |
| Broil Element Wattage | 3600 Watts |
| Color | Stainless Steel |
| Cooktop Surface | Ceramic Glass |
To Next Page
