After
Self-Cleaning
You may notice some white ash in the oven. Just wipe
[f the oven is not clean after one clean cycle, repeat
i
[
up with a damp cloth after the oven cools.
the cycle.
[f white spots remain, remove them with
a
soap-filled
If the shelves have become hard to
slide,
wipe the
steel
woo]
pad.
Be
sure to rinse thoroughly with
shelf supports with cooking oil.
a vinegar
and
water mixture. These deposits are
NOTE: No functions
can
be
programmed before the
usually a salt residue that cannot be removed by the
door automatically unlocks.
clean
cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1.
Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the AUTO SELF CLEAN pad.
4. Press
[he
INCREASE or DECREASE pad until
the desired Clean Time appears.
5. Press the STOP TIME pad.
6. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
Delay
Start is setting the oven timer to start the clean
cycle
automatically ‘at a later time than the present
time of day.
NOTE:
Before
beginning, make sure the oven clock
shows the correct time
of day.
1.
Follow steps to prepare the oven for cleaning.
❑
2. Press the AUTO SELF CLEAN pad.
AUTO SELF
CLEAN
A
A
3. Press the INCREASE or DECREASE
o
pad to enter the Clean Time.
❑
4. Press the STOP TIME pad. “SET STOP
STOP
TIME” and the earliest Stop Time you
TIME
can set will appear in the display.
A
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If the
Clean Time is three hours and the time
of
day
is
6:00,
the Stop Time that appears in the display will be
9:00.
5. Press the INCREASE pad to change the Stop Time
to a later time of day if desired. For example:
If you set the Stop Time at 11
:00,
the oven will start
clean cycle at
8:00
and end at 11
:00.
The door
latches automatically.
The self-clean cycle will automatically begin
after “CLEAN” is displayed and the time
for
the
Clean cycle is set. The words “ON” and “LOCK”
will appear in the display when
the
door
automatically
locks.
It will not be possible to open
the oven door until the temperature drops below the
lock temperature and the LOCK light goes
off.
6. When the LOCK light is off, open the door.
NOTE:
●
During a delayed self-clean operation you can find
out when the oven is set to turn on by pressing and
holding the CLEAN pad for 3 seconds.
● A fan may automatically turn on
and
off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
(C[)ntinlled
ne.rt
pclge)
25
To Next Page
Loading...
