Installation Instructions
TOOLS YOU WILL NEED
# 1 and#2Phillipsscrewdriver
Pencil
Tinsnips(forcutting
damper,if required)
Scissors
(to cuttemplate,if necessary)
Gloves
Safetygoggles
Saw(saber,holeor keyhole)
Rulerortape measureand
t edge
Electricdrill with ¾_" VS"and%"
drill bits
Studfinder er Hammer(optional)
Level
(optional)
Fillerblocksor scrap
woodpieces,if needed
for top cabinetspacing
(usedonrecessedbottom
cabinetinstallationsonly)
Ductandmaskingtape
MOUNTING SPACE
66" ormore
fromthe floor
tothe top of
the microwave
Bottomedgeof
cabinetneedsto
be30" or more
fromthe cooking
surface
Backsplash
NOTES:
• Tile space betweei] tile cabiilets inust be 30" wide
aild flee r)f r)bstructir)ils.
" If the space betweei] the cabinets is greater
than 30", a Filler Panel Kit inay be used to fill
in the gap betweei] the iniciow, tve oven and the
cabinets. Your Owner's Manual contains the kit
iminber for your inodel.
" This iniciow:tve ()veil is fi)r installation over
ranges up to 36" wide.
" If you are going to vent your iniciow, tve oven to
the outside, see Hood Exhaust Section fi)r
exhaust duct preparation.
• When installing the microwave oven beneath
smooth, flat cabinets, be careful to follow the
instructions on the top cabinet template for
power cord clearance.
7
To Next Page
Loading...
Need help?
General
