GE JVM1430 - Determining Wall Plate Location Under Your Cabinet

Installation Instructions
DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET
Plate position - beneath flat bottom
cabinet
MountingPlateTabs
i the CabinetBottom
-::
IIIFL
At least 30", up to 36"
Plate position - beneath framed recessed
cabinet bottom
Mounting Plate Tabs
Touching the Back
Frame
tl
30" to Cooktop
Plate position - beneath recessed bottom
cabinet with front overhang
Mounting Plate with
Tabs Below Cabinet
Bottom the Same
Distance as the Front
_gDepth
Your cabinets may have decorative trim that interferes
with the microwave installation. Remove the decorative
trim to install the microwave properly and to make it
level.
THE MICROWAVE MUST BE LEVEL.
Use a level to make sure the cabinet bottom is level.
If the cabinets have a flont overhang only, with no
back or side flame, install the mounting plate down
the same distance as the flont overhang depth. This
will keep the microwave level.
[] Measure the inside depth of the flont overhang.
[] Drmva horizontal line on the back wall an equal
distance below the cabinet bottom as the inside
depth of the fiont overhang.
[] For this type of installation with fiont overhang only,
align the mounting tabs with this horizontal line, not
touching the cabinet bottom as described in Step D.
tt
tt
30"to Cooktop
9