To Next PageTo Next Page
Need help?Do you have a question about the GE JVM1740SP1SS and is the answer not in the manual?
General| Brand | GE |
|---|---|
| Model | JVM1740SP1SS |
| Category | Microwave Oven |
| Language | English |
Essential safety precautions for installation and operation to prevent injury or damage.
Specifies voltage, frequency, amperage, and circuit needs for proper electrical connection.
Details ductwork components, lengths, and calculations for external venting.
Defines liability and procedures for addressing damage during transit or installation.
Lists all hardware, templates, and accessories provided with the appliance.
Enumerate the necessary tools required for a successful installation.
Specifies required clearances above the cooktop and surrounding cabinets.
Guides on finding studs, determining location, and aligning the wall mounting plate.
Introduces the three main ventilation methods: top exhaust, back exhaust, and recirculating.
Securing the mounting plate to the wall using appropriate hardware.
Drilling holes and preparing the cabinet for the microwave and exhaust.
Lifting and securing the microwave oven to the mounting plate and cabinet.
Positioning the exhaust adaptor for connection to the house ductwork.
Sealing the exhaust duct joints to ensure proper ventilation.
Cutting an opening in the rear wall for the external exhaust duct.
Securing the mounting plate to the wall, ensuring alignment with studs.
Drilling holes in the cabinet for power cord and mounting screws.
Modifying the blower unit and its wiring for back exhaust configuration.
Lifting and securing the microwave oven to the mounting plate and cabinet.
Securing the mounting plate to the wall using appropriate hardware.
Drilling holes in the cabinet for the power cord and mounting screws.
Modifying the blower unit for ductless recirculation, ensuring proper wire routing.
Lifting and securing the microwave oven to the mounting plate and cabinet.
Inserting the charcoal filter into the unit for air recirculation.
Verifying correct installation and removing packing materials.
Plugging the power cord into a dedicated, properly grounded electrical outlet.
