GE JVM1950 - Outside Back Exncust; Attach Mounting Plate to Wall

Installation Instructions
B |;OUTSIDE BACK EXHAUST (Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Mounting Plate to Wall
B3. Prepare Top Cabinet
B4. Acjust Blower
B5. Mount the Oven
Bi} PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for outside
exhaust.
* Read the instructions on the REAR WALL TEMPLATE.
* Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the wall plate.
* Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
15
B2}| ATTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to %" onto each bolt.