EasyManuals Logo

GE OPAL XPIO13BCBT User Manual

GE OPAL XPIO13BCBT
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
49-1000464 Rev. 0 11
SIDE TANK ACCESSORY
Side Tank Accessory
NOTE:TherearetwodraintubeslocatedonthebackofyourOpalNuggetIceMakerindicatedasdraintubeAandB
in the illustration on page 12.
1.HandWashOnly:RinseandhandwashOpalSide
Tankwithwarmwaterandamilddishsoap.Remove
OpalSideTank’scapandwashthecapandrubber
valvewithwaterandamilddishsoap.TheSideTank
base can be washed by disconnecting the hose and
addingasmallamountofsoapywatertoit.Scrubas
needed and rinse thoroughly. The rinse water should
drain out the port in the back.
Rinsethecap,rubbervalve,tankandthebasewellto
remove any residual soap (see illustration).
DO NOT WASH THE SIDE TANK IN THE
DISHWASHER.
2.UnplugOpalNuggetIceMaker.UnhookOpal’sdrain
tubes and drain the water from the reservoir.
3.Connectdraintube,labeledB,tothebackofOpalSide
Tank’s base.
4. Make sure drain tube (A) is connected to the black
hanger and installed on the back of Opal.
5.Makesuredraintube(B)connectingtotheSideTank
isrestingflatonthecountertop.
SideTank
Cap and
Valve
Unplugthis
draintube(B)
from the black
hanger and
connect this
tube to the
SideTank.
PlugdraintubeB
into the side tank
here.
B A
TubeB
attached to
the side tank
TubeB
attached to
the side tank
6.PlaceOpalSideTankontherightorleft-handsideofthetheOpalNuggetIceMaker.Usingthesidetankattachment,
slide the shorter side of the attachment under the unit, near the front of the unit. The attachment will slide into a slot on
thebottomoftheunit.Oncethisisplaced,thesidetankcanslideontotheoppositeattachment.Seeguresbelowand
onnextpage.
NOTE: Care should be taken to connect the correct tube to the Opal Side Tank. Tube (B) should always be
connected to the Side Tank whether it is installed on the left or right side of the Opal Nugget Ice Maker. It is
important to make sure the tube is lying at, otherwise water may not ow from the side tank into the ice maker.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE OPAL XPIO13BCBT and is the answer not in the manual?

GE OPAL XPIO13BCBT Specifications

General IconGeneral
BrandGE
ModelOPAL XPIO13BCBT
CategoryIce Maker
LanguageEnglish

Related product manuals