49-1000418 Rev. 8 11
MAKING ICE
Making Ice with Opal
Draining Opal
Water Filter
Once Opal has been cleaned/sanitised, move the ice maker to its desired location and complete the following steps.
5HPRYHLFHELQ
2. Fill reservoir with potable (safe to drink) water up to
WKH0D[)LOOOLQH:DWHUKDUGQHVVPXVWEHOHVVWKDQ
JUDLQVSHUJDOORQ'RQRWILOOUHVHUYRLUZLWKDQ\
OLTXLGH[FHSWZDWHU8VLQJDQ\OLTXLGH[FHSWSRWDEOH
water is misuse and will void your warranty.
3. Plug the ice maker into a grounded outlet.
4. Touch the display button to start the ice maker. The
display will flash green to indicate the ice maker is
ON, then transition to the falling white display.
2SDOZLOOEHJLQWRSURGXFHLFHLQPLQXWHV,WZLOO
continue to make ice until the bin is full, or it runs out
of water. To continue making ice, just add more water.
:HUHFRPPHQGGUDLQLQJ\RXU2SDOZKHQ
<RXSXWLWDZD\RUDQ\WLPHLWVEHLQJUHORFDWHG
2. You turn it off for more than a few days. (i.e. vacation)
3. You are not using much ice. Continous recirculation
of meltwater may affect taste. For best results, drain
your Opal.
The Opal Water Filter, is available at GEAppliances
and is the only water filter compatible with Opal. Please
follow the installation instructions included with your filter.
NOTE: 5HPRYH\RXUZDWHUILOWHULILQVWDOOHGDQG
reinstall the screened intake cap prior to cleaning your
Opal.
:DWHU5HVHUYRLU
0D[¿OOOLQH
:DWHU¿OWHUVQDSVLQWRSODFH
6LGH9LHZ )URQW9LHZ
Water Filter
To Next Page
Loading...
Need help?
General
