Before you call for service…
22
Problem Possible Causes What To Do
Dishes and flatware
Inlet water temperature • Raise the water heater
not clean
is below 120°F. temperature to 120°F.
• Use
HI TEMP WASH.
Water pressure is • Turn on a faucet. Is water
temporarily low coming out more slowly
than usual? If so, wait until
pressure is normal before
using your dishwasher.
Air gap is clogged • Clean the air gap.
Improper rack loading • Make sure large dishware
does not block the
detergent dispenser or the
wash arm.
Spots and filming
Extremely hard water • To remove stubborn spots
on glasses and
from glassware:
flatware
Low inlet water
1
Remove all metal
temperature utensils from the
dishwasher.
Overloading the
2
Do not add detergent.
dishwasher
3
Select the
POT SCRUBBER
cycle and
HEATED DRY
Improper loading option.
4
Start the dishwasher and
Old or damp powder allow to run for 26
detergent minutes. Dishwasher will
now be in the main wash.
Rinse agent dispenser
5
Open the door and pour
empty 2 cups (500 ml) of white
vinegar into the bottom of
Too little detergent the dishwasher.
6
Close the door and allow
to complete the cycle.
If vinegar rinse doesn’t
work: Repeat as above,
except use 1/4 cup (60 ml)
of citric acid crystals
instead of vinegar.
Safety InformationOperating InstructionsTroubleshooting TipsCustomer Service
To Next Page
Loading...
Need help?
General
