49-60466-6  5
Glass Shelves
Tempered glass shelves in the beverage center unit 
are removable for easy cleaning or for storing larger 
items.
To remove a shelf, open the door completely to avoid 
potential damage to the gasket. Lift up on the back of 
the shelf slightly. Tilt the shelf to one side at an angle 
while pulling forward.
To replace a shelf, open the door completely to avoid 
potential damage to the gasket. Tilt the shelf to one 
side at an angle and slide toward the back wall, placing 
one side onto the shelf support. Place the other side 
onto the opposite shelf support. Ensure rear locking 
tabs are engaged. When installed properly, the shelf 
will not slide forward when gently pulled.
To remove, lift up on the 
back of the shelf
Loading Tips and Suggestions
•  The bottom two full extension drawers hold six 
bottles each and are loaded with necks facing the 
rear. Tall bottles should not be loaded on the bottom 
drawer because they may prevent the door from 
closing.
 'RQRWDOORZFKLOGUHQWRFOLPEVWDQGRUKDQJRQWKH
beverage center shelves or full extension drawers. 
They could seriously injure themselves and possibly 
cause 
damage to 
the beverage 
center.
Bottom drawer arrangement
USING THE APPLIANCE: &RQWUROVDQG)HDWXUHV%HYHUDJH&HQWHU
Controls and Features - Beverage Center
Temperature Control
The operating temperatures of the beverage center 
range from the low forties to the mid fifties. This 
appliance is not a refrigerator and does not maintain 
WHPSHUDWXUHVOLNHDUHIULJHUDWRUEHORZ)
'RQRWLQVWDOOWKHEHYHUDJHFHQWHUZKHUHWKH
WHPSHUDWXUHZLOOJREHORZ)&RUDERYH)
(32°C).
As with any refrigeration-type product, there is a slight 
temperature variance at different locations within the 
cabinet.
The coolest area will be in the lower part of the 
cabinet.
The cooler area will be in the middle section.
The upper part of the cabinet is the warmest section.
When the temperature is adjusted, allow 24 hours for 
WKHXQLWWRVWDELOL]H
To set the control, turn 
it to the midpoint setting 
DSSUR[LPDWHO\)2QFH
the beverage center is 
loaded, allow at least 24 
hours before making any 
adjustments to the initial 
setting.
NOTES: 
•  This unit is designed for storing and cooling 
beverages. It is not intended for the storage of 
perishable foods.
•  The lowest temperatures are found on the lower 
shelves/racks and toward the rear of the shelves/
racks.
Tilt the shelf at an angle 
while removing or replacing
Place in slots when replacing 
the shelf