In case of a spillage, you can take the following steps to
easily clean the exterior door:
Open the exterior access door1.
Use the at part of the screwdriver to remove the 2.
door from the base on the left hand side.
Find the hinge and screw the screwdriver into it.3.
Once you have unscrewed the hinge, pull the door 4.
to the right until it comes away.
To replace the door, rst attach it to the bolt on the 5.
right-hand side.
Slide the edge to the right using the screwdriver, 6.
and align it with the marked groove.
Use light movements until you hear a click 7.
indicating that the door is properly positioned.
SMART FILL ICE FACTORY
(only available with certain models)
This no-spill ice-maker with removable cylinder
feeds directly into the ice-tray. It comes with a
storage box that can hold up to 900g of ice.
STARTING UP
Remove the water cylinder found at the top of the
SMART FILL ICE FACTORY (SFIF) by pulling the
top middle part towards you.
Once removed, place the water cylinder on a at
surface. Open The top, which you’ll nd in the middle
centre. To avoid spillages, make sure that there’s
no residual ice obstructing the valve of the cylinder
before you ll it with water. Pour 180 ml of puried
water into the cylinder or ll it to the maximum level.
Replace the top, placing pressure on the middle.
It’s essential that it’s secure in the centre in order to
avoid water leaking out.
To Next Page
Loading...
