61
CLEANING THE TRAY
Firstly, open the front door where 1.
you see a small lip on the right-hand
side. Pull the door towards you until
completely open.
Then, to remove the ice-tray from its 2.
tting, take it by the right-hand side
and at the same time, pull it down and
towards you. Finally, pull it out by the
centre, keeping it horizontal.
To replace the ice-tray in the Smart Fill 3.
Ice Factory, align the short sides with
the lateral ttings and push it until it’s
completely inserted.
Afterwards, push the tray by the right-4.
hand side until you hear a click, which
will ensure the tray securely in place
while working. Close the lid of the Smart
Fill Ice Factory. Your device will be ready
for use once again.
IMPORTANT: Use tepid water to remove residual ice which
will form with regular use of the Smart Fill Ice Factory. This
residue could form on the lid you use to ll the water cylinder,
the cylinder valve, and the ice-box, thus affecting the working
of different parts of the system.
Don’t use ice-picks, forks, or knives to remove the residual
ice as to do so could damage the Smart Fill Ice Factory.
To Next Page
Loading...
