Design Information
Buill-I_ Speedcook Ove_,_
Product
Dimensions
15"
28-7/16-- [--(Recessed
/
/ Portion)
15-27/32_.._25/32"_JJ
Models ZSC2001,ZSC2000
15"
28-7/16'_'_( ReCr_iS0Sn_d__
15-27/32q _ 29-25/32''_
ModelsSCB2001,SCB2000
21-7/8"
22-3/8"
27/32"_
20-27/32" D -...
_27/32" "',
[
7/8" 15/32"4_11/16"
7/8"
27/32"_
*. 14-1/8"_
,_ qL 1-1/16"
V _
20-27/32" D "'".
_27/32"
,
::::::::7_zA
15/32"41_11/16"
Advance
Plannin, g
• These ovens may be installed directly into a
wall or wall oven cabinetry, 30" rninirnurn
width.
• Tire fl'ont surlhce of tire oven will be nearly
flush with surrounding cabineti T doors.
• This oven can be installed over any GE/
Monogram single electric built-in oven or a
single (;E/Monogram electric built-in
warrning drawer.
• This oven rnust be installed at least 36" above
tire floor.
IMPORTANT: This oven is not approved
J()i" use above another built-in Speedcook
oven, side bv side or under tire countertop
installations.
• For personal salety, this oven cannot be
installed in a cabinet arrangernent such as an
island or peninsula.
• Cabinets installed ac!jacent to wall ovens rnust
have an adhesion spec of at least 194°F
temperature rating.
• Allow tor clearance to ac!jacent corners, walls,
ch'awei's, etc.
oots and
MatoiaLs
Required
Tools and Materials Required:
• 2 x 4 or 2x 2 lumberfor runners
" Saw
* Level
, Drill and3/32" bit
, Phillips screwdriver
• Wood screws and adhesiveor other hardware for installing
runners or shelfto supportoven.
Electrical Requirements
• Junction box
• Electrical cable- 3-conductoror 4-conductorwire, as required
by local codes.
• ULlisted conduit connector
• Wire cutters and wire stripper
To Next Page
Loading...
