Introduction
2097937-001 Rev E T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 9
12 June 2017
grounding provides a path of least resistance for an electric
current. Ungrounded connections must not be used.
No other equipment may be used on the electrical circuit with
the treadmills. Do not use extension cords. Using a shared or
unreliable circuit can also cause the treadmills to
unexpectedly shut off, potentially resulting in injury to the
patient.
Ensure the master power switch is in the off position before
plugging in the T2100-ST1 or T2100-ST2. A power surge could
damage the sophisticated electronic system of the treadmills.
WARNING:
Before permitting anyone to use the T2100-ST Series, do the
following:
Warn each user about the risk of falling while the belt is in
motion.
Stress the need for caution.
Demonstrate the proper mounting and dismounting
methods.
Show each user how to use the T2100-ST Series as
described in this manual.
Ask each user to perform a supervised "test usage" at
minimum belt speed to review and practice usage
techniques.
Observe all the precautions listed under “Responsibility of
the Customer“ on page 12 to reduce the possibility of
serious injury as a result of falls or loss of balance.
WARNING:
Serious injury or death could result from electrical shock. To
reduce the possibility of electrical shock, carefully observe
the following precautions.
To disconnect the treadmill, set the power switch to the OFF
position, and remove the plug from the outlet. When the
power is off, the green light on the power switch is dark.
Never operate the unit with a damaged power cord or plug.
Power cord should be routed through frame mounted clamp
and kept clear of the elevation mechanism.
Keep the power cord out of traffic areas and away from
heated surfaces.
Never use extension cords.
Never operate the unit when it is wet.
To Next Page
Loading...
Need help?
General
