Need help?Do you have a question about the GE T2100-ST2 and is the answer not in the manual?
Provides essential information for safe use and regulatory compliance.
Details required safety tests like AC line voltage and ground continuity.
Provides a table linking error codes to possible failure modes and guidance.
A flowchart to diagnose incoming power issues for 110-240VAC.
Guides users to identify error codes based on LED flashing patterns.
Provides estimated durations for replacing various treadmill components.
Step-by-step instructions for removing and replacing the drive motor.
Detailed procedure for removing and installing a new running belt.
Instructions for replacing or flipping the treadmill running deck.
Procedure for removing, adjusting, or replacing the elevation actuator.
Instructions for removing and replacing the emergency stop button.
Details the procedure for calibrating the treadmill's speed accurately.
Provides steps to calibrate the treadmill's elevation system.
Details the verification process for successful system speed calibration.
Describes the verification process for successful system elevation calibration.
Guides on performing essential electrical safety tests, including leakage.
A table listing FRUs with associated tools and procedures for repair.
To Next Page
General
