2021403-028A Series 2000 Treadmill 1
17 December 2004
Instructions
PN 2021403-028
Series 2000 Treadmill
Installation Instructions
Revision History
Tools Required
To install the Series 2000 Treadmill, you will need the following tools:
Multi-meter
Standard hand-tools
Allen wrench (included with treadmill)
Carpenter’s level
9/16 or 15 mm Socket wrench
Installation Checklist
The Installation Checklist is provided as a tool for the field engineer to use as
the installation procedures are followed. The procedures in this instruction
MUST be followed and completed in the order in which they are written and
appear. DO NOT rely on this Installation Checklist for proper installation of
the Series 2000 Treadmill.
Follow the installation instructions in the sequence presented in this
instruction. As you complete each item, check it off in the list below.
AC Power Check - page 2
Assemble Series 2000 Treadmill - page 2
Install Handle Set - page 2
Assemble Emergency Stop Switch - page 4
Check Treadmill Level - page 7
Ground Continuity Test - page 5
Calibrate treadmill - page 6
Connect to controlling device - page 8
Emergency Stop Switch Check - page 9
Adjust Belt Tracking - page 9
Tie Cables down - page 10
Perform functional checkout - page 10
Check handles - page 12
Perform Leakage Test - page 12
Revision Date Description
A 17 December 2004 Initial Release of Document
To Next Page
Need help?
General