EasyManuals Logo

GE T2100-ST2 Service Manual

GE T2100-ST2
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #158 background imageLoading...
Page #158 background image
Component/FRU Removal and Replacement
158 T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-002 Rev G
11 March 2019
Replacing the CE filter
Tools Required
o
Flat Head Screwdriver
o
Grounding Wrist Strap
o
Pliers or adjustable wrench
Approximate time to complete: 30 min
1. Turn treadmill main power switch to the OFF position.
2. Unplug the treadmill plug from the wall receptacle.
3. Allow the treadmill to discharge for 1 minute.
4. Remove the (5) hood-securing bolts.
5. Remove the hood and set it aside.
CAUTION:
Use ESD precautions, including wearing a grounding
wrist strap that is connected to an exposed metal
connection point on the treadmill chassis. Put on the
grounding wrist strap and ground it to the power cord
ground screw.
6. With pliers or an adjustable wrench, hold the 11/32" nuts
while removing the two (2) #8-32 screws with a flathead
screwdriver.
7. Remove the quick disconnect wire connection from the
inline filter.
Note the wires location for replacement.
Power Cord with C-19
appliance connector
¼”-20 Bolt
Clamp

Table of Contents

Other manuals for GE T2100-ST2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE T2100-ST2 and is the answer not in the manual?

GE T2100-ST2 Specifications

General IconGeneral
BrandGE
ModelT2100-ST2
CategoryTreadmill
LanguageEnglish

Related product manuals