GE HEALTHCARE - KRETZTECHNIK VOLUSON® 730EXPERT (BT03)
D
IRECTION 105899, REVISION 3 DRAFT (APRIL 29, 2008) SERVICE MANUAL
4-18 Section 4-4 - Functional Checks
4-4-6-3 Sub Menus
For further details refer to the Voluson® 730Expert Basic User Manual, Chapter 11.
Figure 4-14 3D/4D Sub Menu
Table 4-9 Sub Menus
Step Task Expected Results
1
RENDER VIEW
DIRECTION
To select the desired Render View Direction.
The green line symbolizes the direction of the view.
Note:
The Render View Direction keys are not available in Static 3D Sectional Planes.
2
GRAY CHROMA MAP
Depending on individual requirements a “harder” or “softer” image can be obtained.
3
CONTR. POS
To set the start point of the gamma curve bending. (Graphic display on screen)
Note:
This key is not available in Static 3D Sectional Planes mode.
4
CONTRAST
To set the contrast of the bending. (Graphic display on screen)
Note:
This key is not available in Static 3D Sectional Planes mode.
5
BACKGROUND
Adjusts the contrast of the screen background from dark to bright.
Note:
This key is not available in Static 3D Sectional Planes mode.
6
BALANCE
Only available if a 3D+CFM or a 3D+PD image is acquired.
Note:
This key is only available if a 3D+CFM or a 3D+PD image is acquired.
7
POWER TRESH.
Only available if a 3D+CFM or a 3D+PD image is acquired.
Note:
This key is only available if a 3D+CFM or a 3D+PD image is acquired.
8
3D/4D INFO
On/Off switch to show full or reduced Image Info parameter on screen.
To Next Page
Loading...
