EasyManua.ls Logo

GE Voluson 730Expert - Page 128

GE Voluson 730Expert
332 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GE HEALTHCARE - KRETZTECHNIK VOLUSON® 730EXPERT (BT03)
D
IRECTION 105899, REVISION 3 DRAFT (APRIL 29, 2008) SERVICE MANUAL
4-26 Section 4-4 - Functional Checks
4-4-12 Using the optional MOD (Magneto-Optical Drive)
The optional 3.5 inch Magneto-Optical disk drive supports the following medias:
1.3GB; 640MB; 540MB; 230MB and 128MB
1.) Before installing an MO disk in the MOD, check the MO disk for loose hardware or damaged labels
which could jam inside the MOD. Also, ensure that the slide switch in one corner of the disk is set
so that the disk is write enabled (disk hole closed).
2.) Insert the disk into the MOD with the label facing up.
3.) There are different methods to eject a disk from the MOD. Manual ejection methods are listed below
in preferred order from best (1) to worst (3).
a.) Press the EJECT
switch on the MOD while system is ON.
b.) Press and hold the EJECT
switch while the system is booting.
c.) Mechanical ejection. Insert the end of a paper clip into the hole next to the EJECT
switch while
system power is OFF.
NOTICE
!! NOTICE:
The MOD (Magneto-Optical Drive) is an Option.
Figure 4-16 Magneto-Optical Drive
NOTICE
!! NOTICE:
Never move the unit with a disk in the MOD because the drive actuator will not be locked and
the MOD could break.
NOTICE
!! NOTICE:
Avoid mechanical ejection whenever possible. Mechanical ejection leaves the actuator
unlocked and the MOD susceptible to damage if moved. If forced to use this method, reboot
the system, then insert and eject a known good disk using one of the other manual ejection
methods.
Eject Button
Magneto-Optical Drive
(MOD)

Related product manuals