Beforeyoucall for service...
WATER
Waterfillsanddrains
atthesametime
Possible Causes What ToDo
Sipholfing * If your standpipe or drain fin" the washer is less than 3
feet off the floo_; the water will drain ti'om the till) while
it is filling. I,ifiing the drain hose at least 3 teet off the
floor will allow the wamr to remain in the till) until tile
i)ump drains it out. The anti-siphon clip will lift the drain
hose high enough to do this. The anti-siphon clip is
included with the installation parts package tin" yore"
washeI:
"Another way siphoning can occm _is if the standpipe is
stttfl'ed with rags or other items that prevent air fl'om
escaping with the water: _dr flow is needed to break the
suction.
• Check to make sure only the straight part of tile drain
hose is inserted into the'standi)ipe; no ribs of the drain
hose should be in the standpipe or drain pipe.
"The washer drain ii/llSt be 3 teet or inore off of the floor
to prevent the washer fi'om draining during fill. If your
washer drain is less than 3 teet above the floo_; use the
anti-siphon clip shipi)ed with yore" washer to attach the
drain hose to the back of veto" washe_; The clip will hold
the drain hose in place and ensure that the washer does
not self=drain dm_ing fill. See installation instructions fin.
details.
• Only the straight top portion ot the drain hose should be
inserted into the drain. Inserting the ribbed section of
the hose may create a siphon, and cause the washer to
drain as it fills.
" If the drain opening is excessively tight around tile drain
hose, or if the opening arotmd the hose is closed with
rags or other material, a siphon may occm; and the
washer will drain as it fills. To avoid this problem, ensure
that there is open area around the end _ffthe drain hose
to allow air to flow into the drain as water is i)umped out
of the washe_:
OPERATION Possible Causes What To Do
Washer pauses during This is normal • The washer max, pause durin,,_ the spin cycle to remoxe
spin cycle soapy water inore efficiently.
Washer won't operate Washer is unplugged • Make sure cord is i)lugged securely into a working outlet.
Water supply is turned off • Turn both hot and cold taucets flfllv on.
Controls are not set • Check controls and inake sure Cycle knob is pulled out
properly to ONposition.
Lid is open--safety feature • Close lid and reset c)'cle, to the beginning if necessma:.
prevents agitation mad sphufing
when lid is up
Circuit breaJ_er/fuse is • Check house circuit breake_/fllses. Replace fllses or
tripped/blown reset breaker: Washer should have separate outlet.
PERFORMANCE Possible Causes What ToDo
Colored spots Incorrect me of fabric • Check lid)rio sottener package tin" instructions and tollow
softener directions fin" using dispensex:
" Pretreat stain and rewash.
12 Dye 1transfer • Sort whites or lightly colored items from dark colo_.
To Next Page
Loading...
