Need help?Do you have a question about the GE WBVH6240 and is the answer not in the manual?
Details on the connections to the main control board and its ports.
Details on the connections to the inverter board and its power inputs.
Step-by-step guide to safely remove the control panel assembly.
Description of different operating modes of the control board (Idle, Standby, Run, etc.).
Steps to remove and program a replacement control board assembly.
Detailed steps to remove the entire dispenser assembly from the washer.
Step-by-step guide to remove the dispenser motor from the assembly.
Steps to remove the water level control unit from the washer.
Procedure for disconnecting and removing the water inlet valve assembly.
Detailed instructions on how to remove the washing machine pump, including drainout.
Step-by-step guide to remove the thermistor from the heater assembly.
Instructions on how to correctly install a new thermistor and torque the nut.
Procedure to remove the heater assembly from the outer tub opening.
How the inverter controls the motor and procedures for checking its operation.
Steps to remove the inverter board from its mounting location.
Detailed steps for checking motor resistance via the service panel.
Checking motor resistance through the inverter board terminals.
Step-by-step guide to remove the motor from the washer chassis.
Steps to remove the door hinge assembly from the front panel.
How to remove the main tub gasket that seals the outer tub.
Steps to detach the tub gasket from the water inlet pipe connection.
Procedure for removing the shock absorbers (dampers) from the outer tub.
Steps to correctly install new dampers, ensuring proper alignment.
Detailed steps to remove the wash basket from the outer tub assembly.
Steps to remove counterweights and outer tub screws for basket access.
Procedure to remove the entire outer tub assembly, requiring two people.
Steps to disconnect the suspension springs supporting the outer tub assembly.
To Next Page
General
