Installation Instructions
UNPACKING THE WASHER
_ZlWAR NING: Recycle or destroythecarton
and plastic bags after the washer isunpacked. Make
materials inaccessibleto children. Childrenmight use
them for play.Cartons covered with rugs, bedspreads
or plasticsheetscan become airtight chambers causing
suffocation.
1. Cut and remove all packaging straps.
2. While it isin the carton, carefully laythe washer on its
side.DO NOTlay the washer on its front or back.
3. Turndown the bottom flaps. Remove all base packaging
including the styrofoam base.
4. Carefullyreturn the washer to an upright position and
remove the carton by lifting it upward.
5. Carefully move the washer to within 4 feet (122cm)
of the final location.
6. Removethe following from the back side of the washer:
4 bolts
4 plastic spacers(including rubber grommets)
Do not remove
screw or clip
UNPACKING THE WASHER Icont,}
7. Insertshipping bolt hole covers into shipping bolt holes.
©
s
©
NOTES:
. Failure to remove the shipping braces can cause
the washer to become severelg unbalanced.
. Saveall bolts for future use.
. If you must transport the washer at a later date,you must
reinstall the shipping support hardware to prevent shipping
damage. Keepthe hardware inthe plastic bag provided.
15
To Next Page
Loading...
