Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1.In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C)for proper
washer operation,
2.In an area where it will come in contact with curtains
or drapes.
S.On carpet. The floor MUSTbe a hard surface with
a maximum slope of 1/2" per foot (1.27cm per
30 cm).To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
NOTE:If floor is in poor condition, use 3/4" impregnated
plywood sheet solidly attached to existing floor covering.
IMPORTANT:
Minimum Installation Clearances
. When installed in alcove: Sides, Rear,
Top = 0" (0 cm)
, When installed in closet: Sides, Rear,
Top = 0" (0 cm), Front = 1" (2.54 cm)
Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm_),located 3"
(7.6cm) from top and bottom of door
CONTRACTOR DIMENSIONS
BACK
_,_ 21" 6.25"
(533 mm) _I (159 mm)
-- 4"
(102 ram)
29.75"
(756 mm)
ROUGH-IN DIMENSIONS
FRONT
23.5"
(597 mm)
33.4"*
(849 mm)
SIDE
26.6"
(676.5 mm)
*NOTE:
Washer legs have 0,75" (19 mm) adjustability.
Stacked: 67.7" (172.8 cm)
14
To Next Page
Loading...
